Comark RF500 Bedienungsanleitung PDF herunterladen (Seite 33)

Changing Lithium Battery on RF500 Series

Transmitters

Battery Reordering

RF500 transmitters are fitted as standard with a high power 3.6V Primary lithium-thionyl

chloride C-size cell. Manufacturers part number Saft LSH14 LIGHT or Saft LS26500.

The Saft LS26500 battery can only be used in transmitters manufactured after April-2009.

The date-of-manufacture is encoded in the serial number. The serial number has the

format MMYYxxxx where MM represents the 2-digit month and YY represents the 2-digit

year in which the transmitter was manufactured.

Only replace with the same or equivalent type recommended by Comark. Re-Order

number from Comark: ‘RFBATT’.

Battery Change Procedure

Using a suitable screwdriver undo the two battery cover retaining screws and remove the

battery cover.

Remove the exhausted battery and replace with a fresh one taking care to snap the new

battery in cleanly without making and breaking the contacts repeatedly.

Observe the correct polarity when changing the lithium battery.

Replace the battery cover and do up the two screws taking care not to overtighten them.

Observe any local restrictions on disposal of the used cell.

Check for Transmitter Errors

The removal of the battery will cause the internal clock on the transmitter to reset and so

generate an Error-100 condition. This will be cleared automatically by the Gateway, see

Transmitter Error Codes for details. Verify that the transmitter display shows either no

error or Error-100 only.

Should an Error-400 or Error-500 occur after battery change on a previously working

transmitter try removing and reinserting the battery taking care to snap the new battery in

cleanly without making and breaking the contacts repeatedly.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 41 42

Keine Kommentare

Comark RF500 Bedienungsanleitung Seite 33