Comark RF500 Bedienungsanleitung PDF herunterladen (Seite 28)

Adding Transmitters

Click the Administration button then the Transmitters button.

A categorised list of transmitter serial numbers is displayed. Click the Add New button, a

form will be presented as follows:

Serial Number Enter the serial numbers of the transmitters provided for your

installation. Note that the serial numbers are case sensitive, i.e.

BA03060001 is correct, ‘Ba’, ‘bA’ or ‘ba’ is incorrect and will not

be recognised

Make this a Backbone unit (RF512 and RF513 only)

Those transmitters which have been identified as Backbone

units during the site survey must have this box ticked. Do not

tick this box for transmitters which have no mains adaptor

connected

Disable Display Tick this option to disable the LCD for those transmitters where

the local display is not required

Radio Tx rate This setting controls the rate at which batches of readings are

transmitted to the Gateway. A drop-down-list of minute intervals

is presented, choose a default of 15 minutes unless a faster

update rate is necessary. Updating faster than 15 minutes has

a detrimental effect on battery life

Add to Location Choose an administrative Location for this transmitter.

Locations are described fully in the Gateway Web-View Help

Guide

Enter your password and click the Save button. The newly added transmitter will be added

to the categorised list.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 41 42

Keine Kommentare

Comark RF500 Bedienungsanleitung Seite 28